Assembled E3D V6 All metal hotend 1.75mm V6 Hotend Bowden Extruder 0.4mm Nozzle

v6: Smaller – Easier – Higher Performance.

The v6 has been redesigned from the ground up. the designer has invested a lot of time and used all of their experience to design the latest and greatest Hot End. If you would like to know more about the design process, check out this blog post.

Print the Widest Range of Materials Possible.

Building on their signature high temperature performance that allows you to print high temperature materials they has now focused on adding increased functionality with soft and flexible filaments. By providing a PTFE liner tube through the hot end that you can extend into your extruder this gives the ability to add the confinement and constraint needed to make excellent quality prints with flexible filaments like NinjaFlex, FlexPLA and FlexPolyester. This opens up a huge range of new opportunities for your printer.

High Temperature Peformance.

With no PEEK or PTFE in hot regions of the Hot End you can reach 300C with the supplied thermistor. By swapping a thermistor for a thermocouple (may require additional electronics) you can reach over 400C.

This not only allows you to print extremely high temperature materials like Polycarbonate and Nylons but also eliminates HotEnd meltdown failures associated with PEEK/PTFE designs. Although the latest v6 hotend has a PTFE liner inside the hotend this liner is never subjected to high temperatures so there is no risk of damaging the liner through overheating.

The new Heater Block gives the fastest heat up times and the most responsive temperature control by clamping around the cartridge for maximum thermal contact. The new thermistor placement mean